Swinging Pup

Happy Thursday!

Welcome to my first Design Team post.  

I had fun making an interactive card to fit with the current challenge "Raining Cats and Dogs".  

It's pretty simple and fun to make.

I began by stamping the dog images from AI sets #SC0649 - His and Hers Flying High and #SC0651 - His and Hers Campers onto cyrogen white cardstock and colored with copic markers (colors are listed below).   I then fussy cut both of the pups out.  This step is optional:  I stamped (but didn't color) a second one of each on heavy cardstock.  I fussy cut those out as well just inside the black lines and glued them behind the colored ones.  I like the stability and dimension.  

For the background, I stenciled clouds with Distress Oxide Broken China ink onto a piece of white cardstock and used the largest #5062 - Double Stitch Rounded A2 rectangle die.  I die cut three cloud panels and inked the cloud edge with the same ink.  I die cut each of the cloud panels with the rectangle die as well so that the edges would match up when layered all together.  

For the mechanism - I glued a 3/4 inch wide piece of acetate to the back of the parachute and punched a hole at the top where the pop dot will adhere through to create the swing effect.  I then trimmed up the acetate so that it won't show when the pup swings - see picture below.  I adhered one layer of the clouds directly onto the base cardstock and measured where I wanted the pup to fall.  Then I adhered a pop dot onto the base through the hole.   Place foam tape on the back side of the next cloud layer, leaving space for the swing mechanism.  Before adhering to the card, test the mechanism by holding the cloud layer over the pop dot and make sure your image swings freely.  Remove the pop dot release paper as well and the foam tape and place onto the card.  Lastly, add the last cloud layer over the top of the others. 

   

To finish my card, I added two layers of hillside with patterned paper to the bottom after cutting the bottom/side edges with the AI Double Stitched A2 Rounded rectangle die.  

 

Hope you enjoyed my initial post as an AI Design Team member as much as I enjoyed creating it.  

Have a great day!

Copics used:

E51, E53, E55, E57

B000, B02, B05, B06

Y32, Y35, Y38

R22 & R24